Two-component, polyurethane adhesive, free from solvent and flameproof. Designed for adhesion wood flooring of all kinds, especially pre-finished parquet on to cement slabs, including in-floor radiant heat systems, timber and chipboard,marble and ceramic floors suitably prepared.
|Mixing ratio by weight||: 9/1|
|Density||: 1,6 ±0,05 kg/l (A+B)|
|Open time||: 30 min|
|Pot life||: 60 min|
|Foot traffic after||: 24 hours|
|Sanding after||: 48 hours|
|Average yield||: 1-1,5 kg/m2|
|Tools cleaning||: Thinner|
|Full Cure||: 7 days / at 20C|
|Application tool||: Toothed Trowel|
|Packaging||: 10 kg set|
Before installation, check the moisture content of the subfloor (max. 2%) and of the wood must be 9% ± 2%. The product itself must reach the room temperature before being applied. Also the wood should be kept for 24 hours at least in the same room before being laid, Once mixed, the adhesive may last about 40 min, according to the room conditions (low temperatures extend its pot life). Consumption may vary according to how much the foundation absorbs.Add component B hardener to component A resin and stirring time is S minutes. Using a serrated spatula spread the adhesive on the subfloor, little by little on small areas, and lay the wood immediately, or anyway within 20-25 minutes, Remember to adjust the pieces and hammer on them to enhance adhesion.