Mixing Procedure
It is a two-component product and it should, therefore, be propared at the mix ratio specified for the quantity to be used, taking into consideration the pot life. For a homogenous mixture, make sure that the product temperature should not be less than 15°C. Component A should be stirred by itself by use of a mechanical mixer quickly and then the hardener (Component B) should be added, taking care of the mix ratio. Components A and B should be stirred for minimum 3 minutes until you have a homogenous mixture.
Surface Application
After made ready to apply, the mixture is preferably applied by toothed trowel in amount specified in the paint system or in such amount to obtain he desired dyr film thickness as controlled by wet film comb. Wait time between the coats is minimum 24 hours (20°C) and maximum 5 days. It is very important that the second coat should be applied within the time for overcoating specified above. Air bubbles of the fresh coat thoroughly spread over the surface should be eliminated. (Special care should be shown for it in case of applications of 1 kg/m2 or above 700 microns.) It reaches to a full mechanical and chemical strength in about 7 days.
Material Consumption
Quantity of Novatech floor 3025 to form a coating in thickness of 1 mm over an area of 1 m² is between 1,4-1,5 kg.
Clean Up
Cellulosic or Polyurethane thinner.