HELLTECH FLOOR ADHESIVE FOR ARTIFICIAL TURF-Polyurethane Adhesive for Artificial Turf and Other

Description

Scopes: for gluing of any types of an artificial grass in the field of a seam and marking of the game field on a special tape in and outside of rooms.

Properties

Adhesive and Coating

Rolls of artificial grass unfold and lay close to each other, then bend them partially in the area of the seams and put the tape for the seams exactly in the middle under the joint of the seams. The adhesive tape is evenly applied with adhesive with a notched trowel (B2 or B3) in an amount depending on the structure of the
coating substrate. Consumption 800 g / m2 when applied with a B2 spatula and 1000 g / m2 when applied with a B3 spatula. Laying the coating is done immediately after applying the adhesive for a period of time for laying the coating (about 90 minutes after kneading at a temperature of 23 ° C and a relative humidity of 65%). In this case, it is necessary to make sure that the substrate of the coating is in full contact with adhesive riffs, otherwise
it is necessary to replace the notched trowel. If the coating was laid too late, the result may be incomplete wetting of the coating with adhesive and, therefore, not sufficiently strong bonding. Having laid a covering, it is necessary to grind and roll it with a roller.

During the work, the temperature of the base, coating, adhesive
and in the room itself should not be below 15 ° C, and the relative
humidity of the air should not exceed 75%.

Cleaning tools
Cleaning containers and tools produced immediately after work. Uncured adhesive is well washed off with organic solvents (xylene, solvent, acetone, butyl acetate). Cured adhesive can only be removed mechanically.

Warranty period of storage
Makes 12 months at a temperature from- 0 ° C + 40 ° Cin tightly closed original factory packaging. Do not violate the tightness of the package before mixing the components.

Security measures
Avoid contact with unprotected skin, eyes, inhalation of vapors. If it comes into contact with exposed skin, clean it first with white spirit, then with warm water and soap. In case of contact with eyes, rinse immediately with plenty of running water for several minutes and consult a doctor. Not explosive

Surface Preparation

The surface on which adhesive is applied should be flat, durable in compression and tension, dry, without cracks and dust, free from oils, crumbling areas. To provide adhesive strength of the coating to the base surface should beprimed.
Preparation of adhesive to work
The adhesive is prepared by mixing components A and B in a weight ratio of
7: 1.
The components of the adhesive are packaged and delivered in ratios, ready for mixing. The quality of the mixing components significantly depend on the properties of the adhesive, especially the uniformity of its curing.
Component A is mixed with a drill with a mixing nozzle for 1-2
minutes.

Packing

Compenent A – 21.0 kg, Compenent B – 3.0 kg, When mixing, component B is poured into the container with
component A and stirred until a mixture of a uniform color is formed, especially thoroughly mixed at the edges and at the bottom of the container.

For high-quality mixing, the mixture is poured into a clean and dry container and mix again. It is necessary to mix the amount of adhesive that can be consumed during the pot life of the finished mixture (complete set). Mixed adhesive should be uniform in color and texture. The viability of the adhesive is indicated in the passport. After this time, the adhesive is not suitable for application. This time depends on the ambient temperature – at high temperatures it decreases, and at low temperatures it increases.

Dilution of the adhesive with a solvent is not allowed, as this may cause cracking.