It is an epoxy resin-based, two-component, solvent-free and resilient one-coat lining resistant to fresh water and sea water and cured with polyamine hardener. It can be cured at low temperatures. It is not affected by quick change of weather conditions; does not crack and wrinkle. It does not contain benzyl alcohol, nonyl phenol.
• It is used as protective lining on the inner surfaces of the service water storage tanks at the industrial plants, ships and houses,
• Piping lines for transmission of potable water and salt water,
• On the steel and concrete surfaces.
• Solvent-free with content of solids by 100%
• Forms a hygienic surface and suitable for use in the potable water tanks,
• It can be used on the steel and concrete surfaces.
*dft: dry film thickness
Finish | : Gloss |
Color | : Gray, Oxide Red, Cream |
Density | : 1,30 ± 0,05 kg/lt (A+B / 20°C ) |
Mix Ratio | : 5:1 (A:B – by weight) |
Solid by Volume | : %100 (A+B) |
Pot Life (+20°C) | : 60 minutes |
(+30°C) | : 40 minutes |
Recoating Interval | : Min. 12-14 hours /Max. 7 day (20°C) |
Theoretical Spread | : 2,56 m2/kg (300 mikron dft* da) |
Flammability Point | : >55°C |
VOC | : 0g/l |
Taber Abrasion Resistance | : 80 mg (full cure) |
Full Cured | : 7 day / 20°C de |
Application Methods | : Airless Spray, Roller, Brush |
Thinner | : not diluted |
Recommended Application Thickness | : 300-1000 mikron kfk* |
Mixing Procedure:
It is a two-component product and it should, therefore, be propared at the mix ratio specified for the quantity to be used, taking into consideration the pot life. For a homogenous mixture, make sure that the product temperature should not be less than 15°C. Component A should be stirred by itself by use of a mechanical mixer quickly and then the hardener (Component B) should be added, taking care of the mix ratio. Components A and B should be stirred for minimum 3 minutes until you have a homogenous mixture.
Surface Application:
After made ready to apply, the mixture is preferably applied by airless spray in amount specified in the paint system or in such amount to obtain the desired dry film thickness as controlled by wet film comb. Please not that there will be a difference of 5-10% in thickness between wet film and dry film. For avoidance of any curtaining during application, wet film should be applied maximum in 1000 microns in one coat.
Roller/brush should be used only for lining for cut-off and small
areas. No thinner should be used during application
Store the product in a cool and dry place. Shelf life of the product is 1 year for Components A and B when stored properly in the original container unopened.
Related products
Company
Parquet Products
Waterproof Products
Contact Information
Head Office Address
Orucreis Mah.Tekstilkent Cad. No: 10V Blok No:214 (2. Kat) Tekstilkent Ticaret Merkezi Esenler / ISTANBUL / TURKEY
Factory Address
Buyukbakkalkoy Mahallesi Yakacik Yolu Sokak No: 2/1 Merkez
Maltepe / ISTANBUL / TURKEY